Difference between revisions of "Instructions"
(Created page with "# Initialise the laser 1. First close switches on the wall <img src="~/images/mains.jpeg" alt="240v" width="20%" height="20%" /> 2. Boot up the PC <img src="~/images/pc...") |
|||
| Line 2: | Line 2: | ||
1. First close switches on the wall | 1. First close switches on the wall | ||
| − | + | ||
| + | [[File:mains.jpeg]] | ||
2. Boot up the PC | 2. Boot up the PC | ||
| − | + | [[File:pc.jpeg]] | |
| + | |||
3. Switch on the laser | 3. Switch on the laser | ||
| − | + | [[laserpower.jpeg] | |
**To avoid tripping the circuit breaker leave a gap between closing each switch** | **To avoid tripping the circuit breaker leave a gap between closing each switch** | ||
| Line 16: | Line 18: | ||
4. Switch on the camera monitor | 4. Switch on the camera monitor | ||
| − | + | [[File:camera.jpeg]] | |
5. Insert Safety Key | 5. Insert Safety Key | ||
| − | + | [[File:laserkey.jpeg]] | |
6. Switch on laser | 6. Switch on laser | ||
| − | + | [[File:keypad.jpeg]]> | |
| − | |||
| + | " alt="keypad" width="20%" height="20%" / | ||
# Load material | # Load material | ||
1. open lid | 1. open lid | ||
Revision as of 13:24, 21 January 2024
- Initialise the laser
1. First close switches on the wall
2. Boot up the PC
3. Switch on the laser
[[laserpower.jpeg]
**To avoid tripping the circuit breaker leave a gap between closing each switch**
4. Switch on the camera monitor
5. Insert Safety Key
6. Switch on laser
>
" alt="keypad" width="20%" height="20%" /
- Load material
1. open lid
2. ensure no obstructions on edge of laser bed
3. place material on laser bed
4. use key pad to position laser on top of material
- Focus the laser
- place 8mm focus under laser
- using two hands slacken laser focus ring and lower on top of perspec
- carefully tighten up
- remove 8mm focus
- download instructions to laser
